Hesheng Hardware Lighting has introduced a device that can replace the COB light source by hand (as shown below), which can be replaced by hand to solve the above problems. The light source holder is first attached to the heat sink or the lamp housing. There are two electrode contacts on the light source holder. The thermal grease is applied to the back of the COB light source.
The positive and negative electrodes of the corresponding light source holder are placed in the light source holder. Rotating the COB source causes the positive and negative electrodes to coincide with the source of the light source. The light source cover is then screwed into the light source holder to be reinforced to fix the COB light source and to insulate the outside. A reflector and lens placement are left on the light source cover.
The company also launched a series of optical components such as reflectors and lenses. Cooperated with the COB light source brands Citizen, Sharp, Corey, Jiyu, etc. Some products have patents.
(This article is related to Sheng Hardware Lighting)
To use the 1.25mm Ribbon Connector, you will need to first ensure that the ribbon cable is properly aligned with the connector. The pins on the connector should be lined up with the corresponding holes on the ribbon cable. Once the cable is properly aligned, you can then insert the connector into the corresponding socket on the device.
Overall, the 1.25mm Ribbon Connector is a reliable and versatile connector that is widely used in the electronics industry. Its high-density design and compatibility with ribbon cables make it an ideal choice for many applications
1.25Mm Ribbon Connector,Pressure Terminal Connectors,Pressure Terminal Connector,Pressure Connectors
YUEQING WEIMAI ELECTRONICS CO.,LTD , https://www.wmconnector.com