The effect of laser cutting parameters on slit width The thickness of the material remains unchanged. Under different conditions of cutting speed or laser power, the effect of laser power on slit width is investigated. The relationship between the cutting speed, the slit width and the laser power. Under the same cutting speed, with the increase of the laser power value, the slit width also showed a linear increase trend; under different laser powers, with the increase of the cutting speed, the slit width narrowed accordingly.
The relationship between the thickness of the quartz material and the width of the slit. The relationship between the thickness of the slit and the thickness of the material is the relationship between the thickness of the material, the power of the laser, and the width of the slit. The relationship between material thickness, cutting speed and slit width. At a certain laser power, as the thickness of the material increases, the slit width becomes narrower. For thinner workpieces, a smaller laser power should be selected; if the laser power value is too large, it will inevitably cause the slit to be too wide, which will affect the surface quality of the cutting surface, such as cracks and scorching on the cutting surface.
For thicker workpieces, the effect of laser power on the slit width is not very significant, and a suitably large power can be selected to obtain a higher cutting speed. At this time, if the laser power is too small, the material will not be cut. For the same laser power, the thicker the material, the narrower the slit; the thinner the material, the wider the slit. The slit width will decrease exponentially as the thickness of the material increases. When the slit width is smaller than the laser beam spot diameter, the workpiece cannot actually be cut. At this time, the power of the laser should be increased to achieve the purpose of cutting.
Cross-over Ethernet Cable is also called cross wire. When the crystal head made by different standards at both ends of the wire is T568A at one end and T568B at the other end, then it is the cross wiring mode.
The crossover cable is used to connect ADSL modems to the HUB HUB (related to the MODEM design, but not all), the HUB to HUB connection without a stage port, and the two computers to each other directly through the network card.The production method is basically the same as above, except that the online order is different from 568B, which adopts the method of exchanging 1-3,2-6, that is, one end is made with 568B and the other end with 568A.
Crossover Lan Cable,Crossover Network Cable,Ethernet Crossover Cable,Lan Cable Cross Connection
Shenzhen Kingwire Electronics Co., Ltd. , https://www.kingwires.com