Rock cutting machine notes - Huaqiang Electronic Network

Single chip microcomputer STM32L151CCU6

Spot Remarks 2017+

Brand AVX TPSE226M035R0125 Low impedance tantalum capacitor AVX 22

Electronic scale crystal oscillator 3.2*2.5mm 3225 16M (16.000MHZ) 12PF 10PPM 20PPM 30PPM

(

1

When the cutter moves to the terminal, it needs to be separated from the machine and the pump after the blade is completely separated from the workpiece, and then the sealing door is opened to disassemble the workpiece.

(

2

Diamond tools are valuable, try to avoid impact when clamping rock, so as to avoid deformation of the blade and affect the cutting quality.

(

3

)

During normal cutting, the feed must not be adjusted quickly to avoid damage to the blades and parts.

(

4

If the host is abnormally sounded during the cutting process, it should be immediately retracted and checked.

(

5

) Always pay attention to the flow of the coolant to prevent the cooling water from being insufficient, which will increase the wear of the blade.

(

6

) should be protected against leakage at any time, to install leakage protectors for work

1

One.