The ONK-LST auto-alignment-specific driver not only includes a position tracking function, it can follow the code output of the previous motor, and performs digital precise proportional control in accordance with the established ratio; it also increases the operation of two proportional linkage control systems. The motor's automatic correction function in the relative position. Applicable to a variety of feeding alignment systems, conveyor systems between conveyors, cross-cutting systems for post-print jams, and the like that require alignment control.
Technical features
1. The design concept of this system is based on “position correction†and replaces the traditional concept of “speed correctionâ€. Therefore, the system responds quickly and accurately. The controlled motor can be turned on at any position, and the automatic synchronization is completed immediately after the signal correction once. It is the fastest model to complete the correction.
2. After restarting after stopping, the synchronization state before shutdown can still be maintained; after the operation, the input signal is still detected at any time, and the fine tuning operation of automatic synchronization is performed at any time.
3. The accuracy of the alignment adjustment can be maintained by the same operation in the full range of operation from the lowest speed to the highest speed.
4. The offset distance between two alignment signals can be set, which greatly increases the system application range.
5. The Motion Control+Servo Drive is a combination of motion controller and servo drive, which replaces the need for special controllers for performing this function or the configuration requirements of traditional PLC plus high-speed governors, saving design man-hours, installation, and procurement costs. Easy to use, simple to set up, easy to wire, and highly reliable.
6. Automatically track the main line feed rate and calculate the position compensation function.
7. The Print Mark can automatically correct the cutting length.
8. Contains humanized automatic length conversion function.
9. The RS-485 interface is included, and the ModBus (RTU) communication protocol can be used to directly set the length data and each operating parameter by the PC or PLC through the human-machine interface.
10. Active calculation of various operational data is conducive to monitoring during system operation.
System diagram
Application area
