Geotextile disc sampler structure and method of use - Database & Sql Blog Articles

Photocoupler

Geotextile disc sampler structure and use method

[Structure and Adjustment]:

1. The cutter blade is a double-sided blade with four pieces, which are evenly distributed in four equal divisions. The blade can be replaced, the specific operation is: loosening the piece

5 Phillips screws (4 screws on each piece), remove the 6-blade platen and the 4-sampling blade, replace with a new blade, press the 6-blade platen, pay attention to make the blade mouth tangentially and make four pieces The edges are in the same plane, then tighten the 5 Phillips screws.

2. There is a real mark on the bottom of the instrument, which is used to fix the pattern, which is easy to cut and prevent the sample from slipping.

3. There is a knurled disc under the corrugated handwheel, which can be used to adjust the thickness of the cut. The specific method is: loosening the piece

3 locking screws, rotating part 2 knurling disc (clockwise reduction, counterclockwise increase). To the thickness value taken, the locking member 3 can be tightened.

Disc sampler

[Instructions]:

1. Take the fabric to be cut, measure the thickness, and adjust the sampler disc according to the above.

2. Place the fabric on the cork mat, place the disc sampler on the fabric, and hold the cover with one hand.

7. Hold the corrugated handwheel 1 in one hand and apply a certain pressure, then rotate the corrugated handwheel 1 clockwise (rotation angle > 90 degrees) to intercept the round specimen.